New Bench and Boot Solutions for Bosch ECU's

Flex Version 6.2.0.0 Released

Magicmotorsport has released Flex version 6.2.0.0. The latest update contains new solutions for programming Bosch engine control units in bench and boot modes.

The new Flex solutions cover Bosch EDC17C63, ME17.U.6, EDC17C61 and MED17.6.9 ECU's installed on Mahindra, Massey Ferguson, Ferrari, Maserati, and CF MOTO cars.

The solutions allow professionals to safely perform chip tuning and repairs with full access to Internal flash and EEPROM memories.

Here are some of the supported vehicles:

• Massey Ferguson MF4200 3.3L
• Mahindra Bolero 2.5D
• Mahindra Xylo 2.5 CRDI 2.5 CRDI
• Mahindra As much as 1.5D
• Ferrari 488 GTB 3.9 V8 Twin-Turbo
• Maserati Ghibli M157 3.0 BiTurbo
• CFMOTO UFORCE 1000

The new bench protocols for BOSCH ECUs are now available for the following software packages:

• FLS0.1 – SW Flex ECU (cars, vans, bikes) OBD + Bench
• FLS0.5 – Package Flex
• FULLFLS0.10 – SW Flex Infineon TC17xx

Reading time: 3 minutes | Writing time: 1.30 minutes

New protocols added:

BENCH

• Massey Ferguson BOSCH EDC17C63: Read / Write / Checksum Internal Flash; Read / Write / Checksum Internal EEPROM; Full Backup
• Mahindra BOSCH EDC17C61: Read / Write / Checksum Internal Flash; Read / Write / Checksum Internal EEPROM; Full Backup
• Ferrari BOSCH MED17.6.9: Read / Write / Checksum Internal Flash; Read / Write / Checksum Internal EEPROM; Full Backup
• Maserati BOSCH MED17.6.9: Read / Write / Checksum Internal Flash; Read / Write / Checksum Internal EEPROM; Full Backup
• CF Moto BOSCH ME17.U.6:: Read / Write / Checksum Internal Flash; Read / Write / Checksum Internal EEPROM; Full Backup

BOOT

• Mahindra BOSCH EDC17C61: Read / Write / Checksum Internal Flash; Read / Write / Checksum Internal EEPROM; Full Backup